Util-Threshold Memory - Dell C9000 Series Reference Manual

util-threshold memory

Configure the high or low memory utilization thresholds for SNMP traps.
C9000 Series
Syntax
util—threshold memory {all | cp | lp slot–id | pe | rp [high
{0-100} | low {0-100}]}
Parameters
all
cp
lp slot-id
pe
rp
{{high | low} cpu-
utilization-
threshold-
percentage}
Default
Command Mode
CONFIGURATION
CONFIGURATION TERMINAL BATCH
• show util-threshold memory
utilization thresholds.
Enter the keyword all to configure the memory utilization
threshold on all switch CPUs: Control Processor, Route
Processor, line cards, and port extenders (PE).
Enter the keyword cp to configure the memory utilization
threshold for the Control Processor CPU.
Enter the keyword lp and the linecard processor (lp) slot-id for
which you want to configure the CPU utilization time. The range
for lp slot-id is from 0 to 11.
Enter the keywordpe to configure the CPU utilization time for
port extenders (PE) configured in the system.
Enter the keyword rp to configure the memory utilization
threshold for the Route Processor CPU.
Enter a percentage value to configure the high or low threshold
level for the percentage of memory a switch CPU can use. The
percentage of memory utilization ranges from 0 to 100.
• High threshold: 92%
• Low threshold: 82%
– Display the configured values of memory
NOTE: The pe option is only available when the
extended bridge feature is enabled.
NOTE: A threshold level of 0 disables Syslog and SNMP
traps.
Control and Monitoring 196