Storm-Control Broadcast (Configuration) - Dell C9000 Series Reference Manual

Version
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
6.5.1.0
storm-control broadcast
(Configuration)
Configure the percentage of broadcast traffic allowed in the network.
C9000 Series
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[packets_per_second in] command.
Parameters
packets_per_seco
nd in
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Description
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the packets per second of broadcast traffic allowed into
the network. The range is from 0 to 33554368.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Storm Control 2127