Xilinx Zynq-7000 User Manual page 526

X-Ref Target - Figure 4-14
MIG outputs are generated with the folder name <component name>.
Only alphanumeric characters can be used for <component name>. Special characters
IMPORTANT:
cannot be used. This name should always start with an alphabetical character and can end with an
alphanumeric character.
3. Click Next to display the Pin Compatible FPGAs page.
Zynq-7000 AP SoC and 7 Series FPGAs MIS v4.1
UG586 November 30, 2016
Chapter 4: LPDDR2 SDRAM Memory Interface Solution
Figure 4-14: MIG Output Options
www.xilinx.com
526
Send Feedback