Xilinx Zynq-7000 User Manual page 309

X-Ref Target - Figure 2-37
Directory Structure and File Descriptions
This section explains the MIG tool directory structure and provides detailed output file
descriptions.
Output Directory Structure
The MIG tool places all output files and directories in a folder called <component name>,
where <component name> was specified on the
design creation flow.
The output directory structure of the selected Memory Controller (MC) design from the MIG
tool is shown here. There are three folders created within the <component name>
directory:
•
docs
•
example_design
•
user_design
Zynq-7000 AP SoC and 7 Series FPGAs MIS v4.1
UG586 November 30, 2016
Chapter 2: QDR II+ Memory Interface Solution
Figure 2-37: Recustomize IP
MIG Output Options, page 285
www.xilinx.com
of the MIG
309
Send Feedback