Show Running-Config Uplink-State-Group - Dell S6100 Configuration Manual

Version
8.3.19.0
8.3.12.0
8.4.2.3
Related Commands
•

show running-config uplink-state-group

Display the current configuration of one or more uplink-state groups.
Syntax show running-config uplink-state-group [group-id]
Parameters
group-id
Defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10.0.2
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.2(0.0)
8.3.19.0
8.3.12.0
8.4.2.3
Example
Related Commands
•
•
Description
Introduced on the S4820T
Introduced on the S4810.
Introduced on the S-Series S50.
uplink-state-group — create an uplink-state group and enables the tracking of upstream links.
Displays the current configuration of all uplink-state groups or a specified group. The valid
group-id values are from 1 to 16.
EXEC
EXEC Privilege
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
show uplink-state-group — displays the status information on a specified uplink-state group or all groups.
uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
Uplink Failure Detection (UFD) 1623