If you configure any allow-remote , the tunnel source or tunnel mode commands fail if the outer header address
family does not match that of the configured allow-remote.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-address | ipv6–
address} command.
Parameters
ip-address
ipv6–address
Defaults
none
Command Modes
INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.3(0.0)
Usage Information
The tunnel interface is inoperable without a valid tunnel destination address for the configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the destination address of the outer tunnel
header. If you configure a tunnel interface or source address, the tunnel destination must be compatible.
tunnel dscp
Configure the method to set the DSCP in the outer tunnel header.
C9000 Series
Syntax
tunnel dscp {mapped | value}
To use the default tunnel mapping behavior, use the no tunnel dscp value command.
Enter the destination IPv4 address for the tunnel.
Enter the destination IPv6 address for the tunnel.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000 and Z9000.
Tunneling
1631