Description - Dell S6100 Configuration Manual

Version
8.3.19.0
8.3.12.0
8.4.2.3
Related Commands
•

description

Enter a text description of an uplink-state group.
Syntax description text
Parameters
text
Defaults none
Command Modes UPLINK-STATE-GROUP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10.0.2
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.2(0.0)
8.3.19.0
8.3.12.0
8.4.2.3
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related Commands
•
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
Syntax downstream interface
Description
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
clear ufd-disable — re-enable downstream interfaces that are in a UFD-Disabled Error state.
Text description of the uplink-state group. The maximum length is 80 alphanumeric
characters.
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
uplink-state-group — create an uplink-state group and enables the tracking of upstream links.
Uplink Failure Detection (UFD) 1619