What To Do Next; Installing Or Removing Optical Modules; Installing Or Removing A Cable Management Bracket; Installing A Cable Management Bracket - Cisco SRS Series Installation Manual

What to Do Next

Step 3
While lifting the hinged PCMCIA slot door up, press the release button for the card slot to disengage the card from the
card, and then carefully pull out the far left removable PCMCIA flash card.
Step 4 Place the removed PCMCIA card on an antistatic mat, or immediately place it in an antistatic bag if you plan to return it
to the factory.
Step 5 If the PCMCIA card slot is to remain empty, close the door to keep dust out, and tighten the captive screw with the
screwdriver. Otherwise, install the new PCMCIA card.
What to do next
If you intend to install a new PCMCIA card, see
What to Do Next
If you intend to install a new PCMCIA card, see

Installing or Removing Optical Modules

See the
information on how to install or remove SFP, XFP, and other modules for your PLIM.
Danger Because invisible laser radiation may be emitted from the aperture of the port when no cable is connected,
avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Note After removing a PLIM, be sure to replace any front (PLIM) side cover plates.

Installing or Removing a Cable Management Bracket

This section contains the following procedures:

Installing a Cable Management Bracket

This section describes how to install a cable management bracket in the LCC.
The horizontal cable management brackets provide cable management capabilities for the MSCs and PLIMs
on the LCC. The following figure shows a midchassis cable management bracket installed on the front (PLIM)
side of the chassis.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
166
Cisco CRS Carrier Routing System Ethernet Physical Layer Interface Module Installation Note
Installing and Removing Line Cards, PLIMs, and Associated Components
Installing a PCMCIA Card, on page
Installing a PCMCIA Card, on page
163.
163.
for