How To Remove Or Install A Card Slide-Assistance Arm (Handle); Msc Impedance Carrier; Plim Impedance Carrier; Rp Impedance Carrier - Cisco Carrier Routing System CRS-1 Installation Manual

Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
Prerequisites
Before performing this task, open the doors if they are installed and ensure that the slot in which you are
about to install the impedance carrier is empty. Depending on the slot in which you are installing an
impedance carrier, see the
PLIM" section on page
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install an impedance carrier, follow these steps:
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2 Use both hands while inserting an impedance carrier. Use one hand on the faceplate and the other hand
along the base of the impedance carrier to guide it into a slot.
Step 3 Slide the impedance carrier into the chassis until the captive screw plates are flush with the chassis.
Step 4 Partially tighten the two captive screws on the front panel of the impedance carrier (either by hand or
with the screwdriver) to make sure that they are both engaged.
Use the screwdriver to fully tighten the captive screws to seat the impedance carrier firmly in the slot.
Step 5

How to Remove or Install a Card Slide-Assistance Arm (Handle)

This section contains the following procedures:
•
•
All line cards, PLIMs, and RPs are shipped with slide-assistance arms (sometimes called handles)
attached. SPAs, the SIP-800, and SFCs are not shipped with slide-assistance arms.
slide-assistance arm attached to an MSC.
OL-10971-10
"Removing an MSC, FP, or LSP" section on page
4-48, or the
ESD-preventive wrist strap
Number 1 Phillips screwdriver
Impedance carrier
SFC impedance carrier (Cisco product number: CRS-4-FC-BLANK)
–
MSC impedance carrier (Cisco product number: CRS-MSC-IMPEDANCE=)
–
PLIM impedance carrier (Cisco product number: CRS-INT-IMPEDANCE=)
–
RP impedance carrier (Cisco product number: CRS-RP-4-BLANK=)
–
Removing a Card Slide-Assistance Arm
Installing a Card Slide-Assistance Arm
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide

How to Remove or Install a Card Slide-Assistance Arm (Handle)

"Removing an RP or PRP Card" section on page
4-37, the "Removing a
4-29.
Figure 4-8 shows a
4-11