Debug Ip Msdp; Ip Msdp Cache-Rejected-Sa - Dell S4810 Reference Manual

debug ip msdp

Turn on MSDP debugging.
S4810
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
packet peer
address
pim
Defaults Not configured.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.2.1.1

ip msdp cache-rejected-sa

Enable an MSDP cache for the rejected source-active entries.
S4810
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{number} command.
1112
Enter the keyword event then the peer address in a dotted
decimal format (A.B.C.D.).
Enter the keyword packet then the peer address in a dotted
decimal format (A.B.C.D.).
Enter the keyword pim to debug advertisement from PIM.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Multicast Source Discovery Protocol (MSDP)