Deny Icmp (For Extended Ipv6 Acls) - Dell S6000 Reference Manual

Command
Version 9.4(0.0)
History
Version 9.3(0.0)
Usage
When the configured maximum threshold is exceeded, generation of logs is
Information
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable command in the Monitor Session mode. When you enable this
capability, traffic with particular flows that are traversing through the ingress and
egress interfaces are examined and, appropriate ACLs can be applied in both the
ingress and egress direction. Flow-based monitoring conserves bandwidth by
monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).

deny icmp (for Extended IPv6 ACLs)

Configure a filter to drop all or specific ICMP messages.
NOTE: Only the options that have been newly introduced in Release 9.3(0.0) and Release 9.4(0.0)
are described here. For a complete description on all of the keywords and variables that are
available with this command, refer the topic of this command discussed earlier in this guide.
Syntax
deny icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} [message-type]
[count [byte]] | [log [interval minutes] [threshold-in-msgs
[count]] [monitor]
To remove this filter, you have two choices:
•
Access Control Lists (ACL)
Added support for flow-based monitoring on the S4810,
S4820T, S6000, and Z9000 platforms.
Added support for logging of ACLs on the S4810, S4820T,
and Z9000 platforms.
Use the no seq sequence-number command syntax if you know the filter's
sequence number
299