SROS Command Line Interface Reference Guide
password <password>
Use the password command to specify the challenge password for simple certificate exchange protocol
(SCEP). Use the no form of this command to allow CA requests to be sent automatically (using SCEP)
without requiring a password.
Syntax Description
<password>
Default Values
By default, no password is required.
Functional Notes
There are two places for configuring a SCEP password:
•
At the (ca-profile)# prompt.
•
If it is not configured at the (ca-profile)# prompt, you are prompted to enter one when going through the
certificate enrollment process.
The password is sent to the CA from which you are requesting a certificate. The CA may then ask for the
password later before a certificate can be revoked. See
Usage Examples
The following example sets the SCEP challenge password to procurve:
ProCurve(ca-profile)#password procurve
5991-2114
Specifies the SCEP password (up to 80 characters).
© Copyright 2006 Hewlett-Packard Development Company, L.P.
CA Profile Configuration Command Set
crypto ca enroll <name>
.
on page 340
1220