Bind The Adsl Interface To The Atm Interface; Additional Settings - HP ProCurve 7000dl Series Basic Management And Configuration Manual

ADSL WAN Connections
ADSL Modules for the ProCurve Secure Router
N o t e
7-28

Bind the ADSL Interface to the ATM Interface

When you configure WAN connections on the ProCurve Secure Router, you
must bind the physical interface to the logical interface. For ADSL WAN
connections, you must bind the ADSL interface to the ATM interface. Enter
the following command from the global configuration mode context:
Syntax: bind <number> <physical interface> <slot number>/<port number> <logical
interface> <logical interface number>
You can also enter this command from the ATM interface configuration mode
context.
For example, if you want to bind the ADSL 1/1 interface to the ATM 1 interface,
enter:
ProCurve(config)# bind 1 adsl 1/1 atm 1
The ATM interface may take a few minutes to establish a connection. To view
the status of the ATM interface and subinterface, enter:
ProCurve(config)# do show interface atm 1
ProCurve(config)# do show interface atm 1.1
The do command allows you to enter enable mode commands (such as show
commands) from any context (except the basic mode context).
If you need to configure PPPoE for your ADSL connection, see "PPPoE
Overview" on page 7-29. If you need to configure PPPoA for your ADSL
connection, see "PPPoA Overview" on page 7-36.

Additional Settings

In addition to configuring the settings to enable and establish the ADSL
connection, you can configure settings such as access controls on the ATM
subinterfaces. Table 7-6 lists additional configurations that you can enter from
the ATM interface and subinterface and the page number where you can find
information about those configurations.