Auto Points - Leica TPS1200 series Technical Reference Manual

48.3
Requirements
Access step-by-step
SURVEY
Survey: Job Name,
Auto page
Survey - Auto Points

Auto Points

<Log Auto Pts: Yes> in SURVEY Configuration, Auto Points page.
Step Description
1. Refer to "47.1 Accessing Survey" to access SURVEY Survey Begin.
2. SURVEY Survey Begin
Check the settings.
3. CONT (F1) to access SURVEY Survey: Job Name.
4. PAGE (F6) until the Auto page is visible.
The Auto page of a typical configuration set is explained. Before logging of auto points has
started, the page appears as shown below:
START (F1)
To start logging of auto points and offset points
if configured or, for <Log By: User Decides>
to start the chain to which the auto points
should be assigned. The first auto point is
stored..
<EDM Mode: Tracking> becomes active. For
<EDM Type: Reflector (IR)> instrument locks
onto reflector. For <EDM Type: Long Range
(LO)> <EDM Type: Reflector (IR)> is set and
instrument locks onto the reflector.
TPS1200 1217