Leica TPS1200 series Technical Reference Manual page 1118

Hide thumbs Also See for TPS1200 series:

Table of Contents

Set Stn & Ori -

Set Azimuth,

<Instrument Ht:> Enter the height of the instrument station.

<Fixpoint Job:> Select the fixpoint job of the control/target points.

The geometric scale correction is displayed.

The correction displayed depends upon the options chosen in CONFIGURE

TPS Corrections, GeoPPM page:

• if <Calc Scale: Automatically>, <Computd Scale:> is displayed.

• if <Calc Scale: Manually>, <Current Scale:> is displayed.

Press CONT (F1) to access SETUP Set Stn & Ori - Set Azimuth.

To set the station and orientation and exit the

Setup application program.

To measure a distance to the point being used

to set the azimuth.

A distance measurement is NOT required

when setting the Station and the Orientation

SET (F1). Checking is NOT performed on the

distance measurement when setting the

Station and the Orientation SET (F1).

Available on the Setup page. To set

<Azimuth: 0> and running. This value is not

set to the system until SET (F1) is pressed.