Setup Results; Least Square And Robust Calculation - Leica TPS1200 series Technical Reference Manual

Hide thumbs Also See for TPS1200 series:

Table of Contents

Stn Coords page

Setup Results

This screen is displayed after a resection or orientation and height transfer calculation.

For the calculations the least square or the robust method can be used. After the station

is set, all following measurements will be related to this new station and orientation.

Press CALC (F5) in the SETUP Measure Target screen.

The screen described consists of the Stn Coords, Sigma, Stn Code and Plot page. The

explanations for the softkeys given below are valid for the Stn Coords and Sigma page.

Refer to "6.3.2 Creating a New Point" for information on the keys on the Stn Code page refer

to "34.6 Plot Mode - MapView Screen Area" for information on the keys on the Plot page.

To set data selected in

setup data and exit the application

To view other coordinate types.

ROBST (F3) or LSQRS (F3)

To display the results for the robust or the

least squares calculation method.

and to store all