Leica TPS1200 series Technical Reference Manual page 1108

Hide thumbs Also See for TPS1200 series:

Table of Contents

New Station Point

• LOCAL (F5) to access SETUP SmartStation One Pt OneStep to enter local

coordinates for the setup point and a name for the local coordinate system.

• CSYS (F6) to access SETUP Coordinate Systems to select an existing coor-

dinate system. In this screen the creating and editing of coordinate systems is

also available.

SETUP New Station Point

• OCUPY (F1) To start the point occupation.

• STOP (F1) To end the point occupation.

• STORE (F1) To store the point information.

Overview of the screen

Important feaures about this screen:

• Upon entering SETUP New Station Point SmartStation switches into GPS mode.

• The display mask for SETUP New Station Point is fixed and is not configurable.

• A coordinate system for the setup is required and should be attached to the active job.

• If not already on, SmartAntenna is automatically turned on upon entry to the screen.

• Some of the screen icons change from TPS specific to GPS specific.

• The occupation/storing behaviour is dependent on the configuration settings.