Leica TPS1200 series Technical Reference Manual page 1011

Field procedure
step-by-step
Reference Line
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. Refer to "42.2 Accessing Reference Line" to access REFLINE Refer-
ence Line/Arc Begin.
2. REFLINE Reference Line/Arc Begin
Select a job and a configuration set with the settings mentioned
above.
3. CONT (F1) to access REFLINE Choose Task & Reference Line,
Reference page.
4. REFLINE Choose Task & Reference Line, Reference page
<Task: Stake to Arc>
<Ref to Use: Select from Job>
5. Highlight <Ref Arc:>.
6. ENTER to access REFLINE Manage Reference Arcs.
7. REFLINE Manage Reference Arcs
Select the correct reference arc.
8. CONT (F1) returns to REFLINE Choose Task & Reference Line,
Reference page.
The Map page provides an interactive display of the defined refer-
ence arc.
9. CONT (F1) to access REFLINE Enter Offset Values.
TPS1200
Refer to
chapter
42.2
42.4.2
42.4
34
1011