Leica TPS1200 series Technical Reference Manual page 1114

Hide thumbs Also See for TPS1200 series:

Table of Contents

STORE (F1) to store the point and then return to SETUP Measure Target.

Refer to "45.6.4 Orientation and Height Transfer" for details on all fields and keys.

• ALL (F1) to measure and store this same point with the TPS station. (The GPS target

point which was previously stored, is automatically suggested as the target point to

measure with the TPS station. This is then the first target point for the station setup).

• GPS (F4) to measure additional target points with GPS.

• DONE (F5) to temporarily exit the Setup program. (This is applicable when Add Points

Later is set. In this state, this type of setup is regarded as an incomplete setup. The

setup can be continued and completed at a later time). This key is replaced by CALC

(F5) when sufficient data is available.

• CALC (F5) to compute the setup results (This is applicable when at least two target

points have been measured and stored).

• SET (F1) to set the TPS station and TPS orientation in the SETUP Results screen. This

setup is now complete. It is still possible to add additional points to the setup to improve

the setup results. Refer to "45.7.2 Additional Information".

The current 3D coordinate quality of the computed

The number of static observations recorded over the

period of point occupation.

Available only when the recording of static observa-

tions is configured. Refer to "22.6 Logging of Raw

Obs" for details.