Calculating The Volume; Step 1) Surveying The Points - Leica TPS1200 series Technical Reference Manual

Volume Calculations
52.4
52.4.1
Description
Access
VOLUMES
Surface Points,
Survey page

Calculating the Volume

Step 1) Surveying the Points

To measure points to a new surface or to an existing surface in the active job. If no surfaces
currently exist in the active job, the user has to enter a New Surface first in VOLUMES
Choose Task & Surface.
within the VOLUMES Volumes & Surfaces Menu are marked grey if no surface exists in
the active job.
Refer to "52.2 Accessing Volume Calculations" to access VOLUMES Surface Points.
The pages shown are those from a typical configuration set. An additional page is available
when a user defined display mask is used.
TPS1200
The menu items Triangulate Surface and Compute Volume
ALL (F1)
To measure and store distances and angles.
STOP (F1)
Available if <EDM Mode: Tracking> and
DIST (F2) was pressed. Stops the distance
measurements. (F1) changes back to ALL.
DIST (F2)
To measure and display distances. Available
unless <EDM Mode: Tracking> and/or <Log
Auto Pts: Yes>, after the tracking or logging is
started.
1304