Leica TPS1200 series Technical Reference Manual page 1133

Hide thumbs Also See for TPS1200 series:

Table of Contents

Records displayed values to the current job. A

distance measurement is not necessary before

pressing REC (F3). After storing the measure-

ment data to the <Job:>, the next <Point ID:> in

the job is displayed. The instrument positions

to the point if enough data is available.

GPS (F4) (Applicable when using SmartPole)

To enter the GPS Survey screen (the same

screen as for SmartRover) and measure a

point with GPS. The antenna height is automat-

ically converted from the reflector height.

Press STORE (F1) to store the point and leave the

GPS Survey screen. The point is stored to the

<Job:> and copied to the <Fixpoint Job:>,

where it can be used as a target for the setup.

Press ESC or SHIFT QUIT (F6) to leave the GPS

Survey screen.

Available when sufficient data (when two or

more points have been measured) is available

for calculation. Runs the setup calculation and

accesses SETUP Results.

DONE (F5) (Applicable to Add Points Later)

To temporarily exit the Setup program. The

station setup will be incomplete but can be

continued and completed at a later time. This

softkey is replaced by CALC (F5) when suffi-

cient data is available.