Leica TPS1200 series Technical Reference Manual page 1040

Reference Plane & Face Scan
Create reference plane
step-by-step
Next step
IF THEN
a new plane is to be CONT (F1) accesses REFPLANE New Reference Plane, General
created page. Refer to paragraph "Create reference plane step-by-step".
points are to be CONT (F1) accessses REFPLANE Measure Points to Plane,
measured to a plane Reference page. Refer to "43.5 Measuring Points to a Reference
Plane".
a plane is to be CONT (F1) accesses REFPLANE Define Scanning Parameters.
scanned Refer to "43.6 Scanning a Plane".
Step Description
1. Refer to "43.2 Accessing Reference Plane" to access REFPLANE
Reference Plane Begin.
2. CONT (F1) to access REFPLANE Choose Task & Reference
Plane.
3. REFPLANE Choose Task & Reference Plane
Select <Plane to Use: Create New Plane>.
4. CONT (F1) to access REFPLANE New Reference Plane, General
page.
NEW (F2) in REFPLANE Manage Reference Planes to
access REFPLANE New Reference Plane, General page.
TPS1200 1040
Refer to
chapter