Staking Out In Orthogonal Mode - Leica TPS1200 series Technical Reference Manual

Hide thumbs Also See for TPS1200 series:

Table of Contents

Orthogonal from and to

Staking Out in Orthogonal Mode

Points can be staked out using orthogonal values to guide to the point to be staked. Values

are relative to the line defined by station and current position. The stakeout elements are a

horizontal distance forwards/backwards, a horizontal distance right/left and a cut/fill. The

values are calculated between the current position and the point to be staked. The values

are calculated either from the station to the point or from the point to the station depending

on the setting of <Stake Mode:>.

<Stake Mode: Ortho from Stn> is configured in STAKEOUT Configuration, General

page. Refer to "46.3 Configuring Stakeout".

Refer to "46.2 Accessing Stakeout" to access STAKEOUT Orthogonal Stakeout.

P1 Current position

P2 Point to be staked

or <Go BACK:>

or <Go LEFT:>

<CUT:> or <FILL:>