SETS
View Residuals in Set
XX
Sets of Angles
Description of columns when calculating angles
Column
Description
Point ID
•
•
•
Use
•
•
Resdl Hz
•
CONT (F1)
USE (F4)
MORE (F5)
This column is always visible.
Point ID of the measured points in the order they were defined and
measured in SETS Measure New Points truncated to six digits
from the right.
The following three columns appear together. By pressing MORE
(F5) these columns are replaced with other columns.
For Yes: The selected point is used for calculations in all sets.
For No: The selected point is not used for calculations in all sets.
Residual in the Hz value of the selected point within the single set.
TPS1200
To access SETS View XX Results.
To set Yes or No in the Use column for the
highlighted point.
To view additional information.
1079