Surveying Points - Leica TPS1200 series Technical Reference Manual

47.2
Description
Access step-by-step
SURVEY
Survey: Job Name,
Survey page
Survey - General

Surveying Points

The Survey application program is used for point measurement. Coordinates for points can
be measured and stored using ALL (F1), DIST (F2) and REC (F3). Refer to "TPS1200
System Field Manual" for an example on surveying with default settings.
The table describes the main access to SURVEY Survey: Job Name.
Access is possible from other screens where individual point measurements are needed, for
example from COGO Inverse with SURVY (F5).
Step Description
1. Refer to "47.1 Accessing Survey" to access SURVEY Survey Begin.
2. SURVEY Survey Begin
CONT (F1) to access SURVEY Survey: Job Name.
The fields shown are those from a typical configuration set.The screen described consists of
the Survey page and the Map page. The explanations for the softkeys given below are valid
for the Survey page. Refer to "34 MapView Interactive Display Feature" for information on
the keys on the Map page.
The fields and functionality of this screen vary slightly when accessed from other application
programs where individual point measurements are needed.
TPS1200 1201