Monitoring - Leica TPS1200 series Technical Reference Manual

Sets of Angles
44.3
Description
Important aspects
Access
Monitoring preparation

Monitoring

• Monitoring is a module integrated within the Sets of Angles application program.
• Monitoring uses a timer to enable repeated and automated angle and distances meas-
urements to pre-defined target points at defined intervals. The ability to configure the
handling of message dialogs during measurement sets is also enabled.
• For monitoring, instruments must be motorised.
• Monitoring is licence protected and is only activated through a licence key. The licence
key can be entered manually or loaded from the CompactFlash card.
• Refer to "44.2.1 Accessing Sets of Angles" for details on accessing Monitoring.
• This step-by-step desciption is an example on preparing a set for monitoring.
• Refer to "44.2 Sets of Angles" for a complete description of the Sets of Angles program.
Step Description
1. From Main Menu: Programs... select Sets of Angles.
1. Press CONT (F1) to access the SETS Sets of Angles Begin screen.
2. Set station coordinates and station orientation - SETUP (F3).
3. Configure Sets of Angles for monitoring - CONF (F2).
For the Parameters page:
• <MeasMethod: A
• <Display Mask: None> (for example purposes only).
• <Stop For: All Messages> (for example purposes only).
TPS1200
I I II II
B B A > (for example purposes only).
1084