44.2.2
Access
SETS
Configuration,
Parameters page
Sets of Angles
Configuring Sets of Angles
Select Main Menu: Programs...\Sets of Angles. CONT (F1). In SETS Sets of Angles
Begin press CONF (F2) to access SETS Configuration, Parameters page.
OR
Press PROG. Highlight Sets of Angles. CONT (F1). In SETS Sets of Angles Begin
press CONF (F2) to access SETS Configuration, Parameters page.
OR
Press SHIFT CONF (F2) in SETS Sets of Angles Menu.
This screen consists of the Parameters page, the Tolerances page and the Logfile page.
The explanations for the softkeys given below are valid for all pages, unless otherwise stated
CONT (F1)
To accept changes and return to the screen
from where this screen was accessed.
DEFLT (F5)
Available for default configuration sets. To
recall the default settings.
PAGE (F6)
To change to another page on this screen.
SHIFT ABOUT (F5)
To display information about the program
name, the version number, the date of the
version, the copyright and the article number.
TPS1200
1059