Leica TPS1200 series Technical Reference Manual page 997

Reference Line
Step Description
<Point ID: S1>
12. ALL (F1) measures and stores the point.
The results are displayed on the screen. The values in the fields indi-
cate the position of the measured point relative to the reference line.
It may happen that a point with the same point ID exists in the job. If
the codes and/or attribute values of the new and the existing point do
not match, a screen opens where they can be corrected.
13. Are more points to be measured?
• If yes, continue with step 14.
• If no, continue with step 16.
14. Walk to the next point
15. Repeat steps 11. to 13.
The Map page provides an interactive display of the defined refer-
ence line and the points measured relative to it. Displayed is also
• the horizontal distance along the reference line/arc from the start
point to the reference point.
• the perpendicular offset from the reference line/arc measured
from the reference point to the measured point.
16. SHIFT QUIT (F6) returns to TPS1200 Main Menu.
The results are written to the logfile.
TPS1200
Refer to
chapter
34
997