Leica TPS1200 series Technical Reference Manual page 1289

Traverse
Step Description
4. TRAVERSE Traverse Begin
Check the settings.
5. CONT (F1) to access TRAVERSE Traverse Information.
6. TRAVERSE Traverse Information
The existing traverse is shown
DATA (F5) to view data of the active traverse.
END T (F6) to end the existing traverse.
SHIFT CONF (F2) to change the configuration settings.
7. CONT (F1) to access TRAVERSE Close Angle.
8. TRAVERSE Close Angle
<FS Type:> To measure onto a known point or a known azimuth.
<Foresight ID:> The point ID of the foresight point.
<FS Azimuth:> Available for <FS Type: Known Azimuth>. Known
azimuth for foresight point.
9. CONT (F1) to access TRAVERSE Backsight, Set:X/X.
10. Repeat steps 7. to 9. from paragraph "Measure traverse step-by-
step". until all sets are measured.
11. TRAVERSE Point Statistics, Pt:X/X
CONT (F1) to view traverse results.
12. TRAVERSE Traverse Results
TPS1200
Refer to
chapter
51.5
51.3
51.5
51.6
1289