Orientation And Height Transfer - Leica TPS1200 series Technical Reference Manual

Hide thumbs Also See for TPS1200 series:

Table of Contents

Requirements

Access step-by-step

Orientation and Height Transfer

For TPS1200 the position coordinates of the station point are required. The instrument is

set up and oriented to one or more known backsight targets.

For SmartStation the position coordinates of the station are unknown and are determined

with GPS real-time. The instrument is set up and oriented to one or more known backsight

For TPS1200 and SmartStation the orientation is determined by sighting to one or more

known target points (maximum of ten target points). Only angles or both angles and

distances may be measured. The height of the station point can also be derived from the

target points.

Refer to the stated chapter for more information on screens.

Press PROG to access the Programs menu.

Select and activate Setup to move to the first screen.

Press CONT (F1) to access SETUP Station Setup.

<Method:> Ensure that Ori & Ht Transfr is selected.

<Station Coord:> Select the source for the instrument station coordinates.

<Station ID:> Enter/Select the instrument station.

<Instrument Ht:> Enter the height of the instrument station.

<Fixpoint Job:> Select the fixpoint job of the control/target points.

<Fixpoints:> Select the method for measuring the control/target points.