Leica TPS1200 series Technical Reference Manual page 1286

Traverse
Step Description
SHIFT GETPT (F4) to get a point from the <Fixpoint Job:> to be
used as closing point, check point or normal foresight point.
9. ALL (F1) to measure and record the foresight points. The measure-
ment settings for the first measurement to each point are used for all
further sets.
10. Repeat step 9. until all sets are measured.
11. TRAVERSE Point Statistics, Pt:X/X
12. CONT (F1) to choose to move to the next station, to measure a side-
shot point, to view traverse data or to end traverse.
SURVY (F3) to measure a sideshot point.
DATA (F5) to view traverse data.
END T (F6) to end traverse.
13. MOVE (F1) to move to the next station.
14. Repeat steps 3. to 13. until traverse is ready to be closed.
TPS1200 1286
Refer to
chapter
51.5
51.5