Leica TPS1200 series Technical Reference Manual page 1135

Setup
Field Option
<∆Azimuth:> Output
<∆Horiz Dist:> Output
<∆Height:> Output
Next steps
IF THEN
more target points ALL (F1) to measure and store distances and angles, or
are to be measured
REC (F3) to store the current measurement, or
GPS (F4) to measure a point with GPS.
the program is to be DONE (F5) to temporarily exit the Setup program. The station setup
temporarily exited will be incomplete but can be continued and completed at a later time.
sufficient target CALC (F5) to access SETUP Results.
points were meas-
Refer to "45.7 Setup Results" for more information.
ured
A maximum of ten target points can be measured and used for the calculation. When the
maximum number of points was measured, the SETUP Results screen is accessed auto-
Description
Displays the difference between the calculated
azimuth and the current horizontal angle.
If <Method: Resection>, displays ----- until sufficient
data for calculation is available.
The difference between the calculated and the meas-
ured horizontal distance.
The difference between the given and the measured
height of the target point.
TPS1200 1135