Defining The Slope Related To A Reference Line/Arc - Leica TPS1200 series Technical Reference Manual

Reference Line
42.4.4
Description
Access step-by-step
Step 1)
activating
the slope method
Step 2)
defining
the slope parameters

Defining the Slope related to a Reference Line/Arc

• It is possible to measure points and stake points on slopes related to a reference line/arc.
A slope can be defined and cut/fill values can then be displayed to the slope when meas-
uring along the reference line/arc. The slope is a plane from the reference line/arc and
extends along the length of the reference line/arc.
• Slopes can be used when measuring to a reference line/arc, staking a point relative to a
reference line/arc or performing a grid stakeout relative to a reference line/arc.
Step Description
1. Refer to "42.2 Accessing Reference Line" to access the Begin screen.
2. CONT (F1) to access REFLINE Choose Task & Reference Line.
3. SLOPE (F3) to access REFLINE Define Slope.
Step Description
1. Ensure that <Use Slope: Yes> is selected.
Step Description
1. Defining the slope type.
TPS1200 978