Leica TPS1200 series Technical Reference Manual page 1100

Hide thumbs Also See for TPS1200 series:

Table of Contents

The appearance of the SETUP Results screen

differs with this setting.

The calculated scale factor and ppm value from the

resection and orientation and height transfer calcula-

tion are displayed in the SETUP Results, Sigma

page. The ppm value may be set in the system as the

geometric ppm value. In SETUP Station Setup the

<Current Scale:> is displayed and PPM (F5) is avail-

The calculated scale factor from the resection calcu-

lation is displayed in the SETUP Results, Sigma

page but cannot be set as the geometric ppm value.

Instrument positions horizontally to the point.

Instrument positions horizontally and vertically to the

Instrument does not position to the point.

To set the direction to the backsight point to zero.

Sets <AR: 0.0000> towards the backsight point. If set

in the current display mask, <AR:> displays the hori-

zontal angle difference between the backsight point

and the measured point. This has no effect on the set

orientation.