Leica TPS1200 series Technical Reference Manual page 1202

Survey - General TPS1200
ALL (F1)
To measure and store distances and angles.
STOP (F1)
Available if <EDM Mode: Tracking> and
DIST (F2) was pressed. Stops the distance
measurements. (F1) changes back to ALL.
DIST (F2)
To measure and display distances. Available
unless <EDM Mode: Tracking> and/or <Log
Auto Pts: Yes>, after the tracking or logging is
started.
REC (F3)
To record data.
If <EDM Mode: Tracking> and/or <Log Auto
Pts: Yes>, records measured point and
continues tracking.
REMOT (F4)
Available if <Use Remote Pt: Yes> is set in the
SURVEY Configuration, Remote Pt page. To
access SURVEY Survey Remote Point.
SETAZ (F5)
To access the SETUP Set Stn & Ori - Set
Azimuth screen to set the horizontal angle.
Refer to "45.6.2 Set Azimuth" for information
on the SURVEY Set Stn & Ori - Set Azimuth
screen.
SETUP (F5) (Applicable to Add Points Later)
Available when the setup is incomplete.
1202