Leica TPS1200 series Technical Reference Manual page 1085

Hide thumbs Also See for TPS1200 series:

Table of Contents

Sets of Angles

<Time Out: 10 secs> (for example purposes only).

<Timer Monit.: Yes> (this option must be selected for monitoring). This will

enable the access to the SETS Define Monitoring Timer screen.

Press CONT (F1) to access the SETS Sets of Angles Menu screen.

Select Measure New Points.

Press CONT (F1) to access the SETS Define Points for Set screen

Enter details of the target point as required.

For each target point, ensure that <Auto Survey: On> is set. This will enable the

automated measurement and recording of the target point in the other face and the

automated measurement and recording of all target points during monitoring.

Press CONT (F1) to access the SETS Select Points - Survey screen.

Measure and record the measurement to the target point as required.

Continue with steps 7/8/9 until all target points for the first measurement set have

been measured and recorded.

Press DONE (F5) to complete the selection of the target points for the first meas-

urement set in one face and to begin the measurement of the target points in the

other face. On completion the SETS Sets of Angles Menu screen will be

Select Measure Sets.

Press CONT (F1) to access the SETS Define Monitoring Timer screen.

Refer to "SETS Define Monitoring Timer" for information about the screen.