Selecting An Existing Reference Line/Arc - Leica TPS1200 series Technical Reference Manual

Hide thumbs Also See for TPS1200 series:

Table of Contents

Access step-by-step

The Reference page

Reference Line

Selecting an Existing Reference Line/Arc

Reference lines/arcs can be created, edited, stored and deleted in the <Control Job:>.

Refer to "42.2 Accessing Reference Line" to access the Begin screen.

CONT (F1) to access REFLINE Choose Task & Reference Line.

REFLINE Choose Task & Reference Line, Reference page.

Select <Ref to Use: Select from Job>.

This screen contains the Reference page and the Map page. The explanations for the

softkeys and the fields are as for manually entering a reference line. The <Method:> field is

not available and all line definition fields are outputs, all other differences are described

The fields shown depend on the options chosen for <Task:> and <Method:> in REFLINE

New Reference XX. Refer to paragraph "Creating a reference line/arc step-by-step".

Description of fields

Available for <Task: XX Line>. The reference line to

be used. Accesses REFLINE Manage Reference