Managing Reference Planes - Leica TPS1200 series Technical Reference Manual

Hide thumbs Also See for TPS1200 series:

Table of Contents

Reference Plane & Face Scan

Choose Task & Refer-

Managing Reference Planes

A reference plane is used to measure points relative to the plane or to scan the plane.

Measure to plane

Reference planes can be created, edited, stored and deleted in the active job.

The reference planes can be recalled for later use.

The plane can be shifted through a point or a defined offset.

Scan a plane

<Task: Scan> in REFPLANE Choose Task & Reference Plane to scan the selected plane

with the defined grid.

To accept changes and to continue with the

subsequent screen.

SHIFT CONF (F2)

To configure the reference plane. Refer to

"43.3 Configuring Reference Plane".