Leica TPS1200 series Technical Reference Manual page 1093

Hide thumbs Also See for TPS1200 series:

Table of Contents

Incomplete setups

For a "Standard" setup, the user must always measure all setup points consecutively to

complete the setup. This type of setup is always regarded as a complete setup.

For an "On-the-Fly" setup, the setup points can be measured together with the survey

points. It is not necessary to complete the setup before measuring survey points. In this

state, this type of setup is regarded as an incomplete setup.

An incomplete setup can be accessed in the following ways:

1. When pressing SETUP (F3) in the Begin screen of a program (other than Setup), a

message is displayed to notify that the setup is incomplete. It is then possible to:

a) start Setup and continue to measure additional fixpoints, or

b) start Setup and create a new station setup, or

c) leave Setup and continue with the existing program

2. When pressing CONT (F1) in the Begin screen of any program, a message is displayed

to notify that the setup is incomplete. It is then possible to:

a) continue with the existing program

b) start Setup and create a new station setup, or

c) start Setup and continue to measure additional fixpoints.

3. Assigning the function FUNC Continue Open Setup to the User Menu or a Hot Key.

* The Setup Reminder screen (if it has been set) is not displayed in this instance.

In the Survey program, Setup can be accessed by SETUP (F5).