Leica TPS1200 series Technical Reference Manual page 1041

Reference Plane & Face Scan
Step Description
5. REFPLANE New Reference Plane, General page
<Ref Plane:> The ID of the new reference plane.
<No. of Points:> Number of points used for plane definition.
<Std Deviation:> Standard deviation of used points for plane defini-
tion. ----- is displayed unless more than four points are used to define
the plane.
<Max ∆d:> Maximum distance between measured point and defined
plane. ----- is displayed unless more than four points are used to
define the plane.
6. PAGE (F6) to change to the Points page.
7. REFPLANE New Reference Plane, Points page.
An * is shown to the right of the point for a point which will be used as
origin of the plane.
An is shown to the left of the point if the point is outside maximum
distance between a point and the calculated plane as defined in
REFPLANE Configuration, Parameters page.
The column ∆d(m) displays the perpendicular distance of the point
from the definition of the plane.
ADD (F2) to add points from REFPLANE Data: Job Name to define
the reference plane.
USE (F3) to change between Yes and No for the highlighted point.
TPS1200
Refer to
chapter
1041