Measuring Traverse - Leica TPS1200 series Technical Reference Manual

51.4.2
Measure traverse step-
by-step
Traverse

Measuring Traverse

Step Description
1. Refer to paragraph "Start traverse step-by-step" to start a traverse.
2. Start the Traverse application program.
3. TRAVERSE Traverse Begin
Check the settings.
4. CONT (F1) to access TRAVERSE Traverse Information.
5. TRAVERSE Traverse Information
The existing traverse is shown
DATA (F5) to view data of the active traverse.
END T (F6) to end the existing traverse.
SHIFT CONF (F2) to change the configuration settings.
6. CONT (F1) to access TRAVERSE Backsight, Set:X/X.
Enter <Instrument Ht:>
7. ALL (F1) to measure and record the backsight point.
8. TRAVERSE Foresight, Set:X/X
<Foresight ID:> The name of the foresight point.
<Reflector Ht:> The reflector height of the foresight point.
<No. of Sets:> The number of sets to be measured.
SURVY (F5) to measure sideshot points.
TPS1200
Refer to
chapter
51.4.1
51.2
51.5
51.3
1285