45.4
Access step-by-step
Setup
Setup with SmartStation
Description
1.
Access SETUP Station Setup Begin.
2.
SETUP Station Setup Begin
Check the settings and ensure that a coordinate system other than <None> or
WGS84 is selected and attached to the active job.
3.
CONT (F1) to access SETUP Station Setup.
4.
SETUP Station Setup
•
Choose one of the following setup methods:
• <Method: Set Azimuth> or
• <Method: Known BS Point> or
• <Method: Ori & Ht Transfr>.
•
These are the only methods applicable for a setup with SmartStation.
•
All setup methods are described in "45.6 Setup Methods".
<Station Coord: From GPS>.
Ensure that the SmartAntenna is connected and the interface is set.
<Station ID:> Enter the instrument station.
<Instrument Ht:> Enter the height of the instrument station.
5.
CONT (F1) to access SETUP New Station Point.
If a coordinate system has not been selected:
TPS1200
1107