Leica TPS1200 series Technical Reference Manual page 942

Hidden Point
Step Description
4. Position the tip of the hidden point rod on a mark that is directly visible
from the instrument location.
5. Repeat steps 4. to 14. from paragraph "Measuring hidden point step-
by-step".
Make sure the hidden point rod does not move between meas-
urements.
6. PROG to access TPS1200 Programs.
7. TPS1200 Programs
Stakeout to access STAKEOUT Stakeout Begin
Make sure <Auto Position: 3D> is selected in STAKEOUT Config-
uration, General page.
8. STAKEOUT Stakeout Begin
CONT (F1) to access STAKEOUT XX Stakeout, Stake page
9. STAKEOUT XX Stakeout, Stake page
Select the hidden point.
Motorised instruments position to the hidden point
TPS1200 942
Refer to
chapter