51.4
51.4.1
Start traverse step-by-
step
Traverse
Traverse Methods
Starting Traverse
The quickest setup method is described.
Step
Description
1.
Start the Traverse application program.
2.
TRAVERSE Traverse Begin
Check the settings.
CONF (F2) to change the configuration settings.
3.
CONT (F1) to access TRAVERSE Traverse Information.
4.
TRAVERSE Traverse Information
<Traverse ID:> The name of the new traverse.
SHIFT CONF (F2) to change the configuration settings.
5.
CONT (F1) to access SETUP Station Setup.
<Method: Set Azimuth>
<Station Coord: Frm Fixpoint Job>
6.
CONT (F1) to access SETUP Select Station
7.
SETUP Select Station
Enter <Station ID:> and CONT (F1).
8.
SET (F1) to set the station and orientation and to access TRAVERSE
Foresight, Set X/X
TPS1200
Refer to
chapter
51.2
51.3
51.3
45.6
1283