Setup With Smartstation - Leica TM30 Series Field Manual

11.3

Setup with SmartStation

Access
step-by-step
SETUP
New Station Point
Setup
Step Description
1. PROG. The PROG key opens the TPS1200+/TS30/TM30 Programs
menu.
2. Select Setup and press CONT (F1).
3. CONT (F1) to access the SETUP Station Setup.
4. SETUP Station Setup Begin.
Check the settings and ensure that a coordinate system other than
<None> or WGS84 is selected and attached to the active job.
5. CONT (F1) to access the SETUP Station Setup screen.
6. SETUP Station Setup.
• Choose one of the following setup methods:
• <Method: Set Azimuth> or
• <Method: Known BS Point> or
• <Method: Ori & Ht Transfr>.
• These are the only methods applicable for a setup with SmartStation.
7. <Station Coord: From GPS>.
Ensure that the SmartAntenna is connected and the interface is set.
<Station ID:> Enter the instrument station.
<Instrument Ht:> Enter the height of the instrument station.
8. CONT (F1) to access SETUP New Station Point.
If a coordinate system has not been selected:
• LOCAL (F5) to access SETUP SmartStation One Pt OneStep to
enter local coordinates for the setup point and a name for the local
coordinate system.
• CSYS (F6) to access SETUP Coordinate Systems to select an
existing coordinate system. In this screen the creating and editing of
coordinate systems is also available.
9. SETUP New Station Point
OCUPY (F1) To start the point occupation.
STOP (F1) To end the point occupation.
STORE (F1) To store the point information.
Overview of the screen
Important features about this screen:
• Upon entering this screen SmartStation switches into GPS mode.
• The display mask for this screen is fixed and is not configurable.
• A coordinate system is required and should be attached to the active job.
• SmartAntenna is automatically turned on upon entry to the screen.
• Some of the screen icons change from TPS specific to GPS specific.
TPS1200+/TS30/TM30 165