Rate-Interval - Dell Z9500 Reference Manual

Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged tengigabitethernet 7/1
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged tengigabitethernet 7/1
Dell(conf-if-vl-20)#interface tengigabitethernet 7/1
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#

rate-interval

Configure the traffic sampling interval on the selected interface.
Z9500
Syntax
rate-interval seconds
Parameters
seconds
Defaults 299 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The output of the show interfaces command displays the configured rate
Information interval, along with the collected traffic data.
832
Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the
number of seconds designated here rounds to the
multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
Interfaces