Table of Contents
Advertisement
authentication
inservice
ipv6
query-user
test-server
user
Config Mode
To move from enable mode to config mode, enter the command config terminal. Users in config mode may return
to enable mode at any time by entering the command exit.
When you are in config mode, (config) appears before the # prompt:
(host) (config) #
Some top-level commands have different sets of subcommands available in Enable or Config mode. To view a list of
available subcommands in Config mode, access the CLI in Config mode, enter the top level command, then enter a
question mark (?). For example, the following example shows which aaa commands are available in Config mode:
(host) (config) #aaa ?
alias-group
authentication
authentication-server
bandwidth-contract
derivation-rules
dns-query-interval
password-policy
profile
radius-attributes
server-group
tacacs-accounting
timers
user
Configuration Sub-modes
Some Config mode commands can enter you into a sub-mode with a limited number of available commands specific
to that mode. When you are in a configuration sub-mode, the (config) that appears before the command prompt will
change to indicate your current mode; e.g (config-if) for config-interface mode, and (config-tunnel) for config-tunnel
mode.
You can exit a sub-command mode and return to the basic configuration mode at any time by entering the
command.
1538 | Appendix A: Command Modes
Authentication
Bring authentication server into service
Internet Protocol Version 6
Query User
Test authentication server
User commands
Configure an Alias Group
Authentication
Authentication Servers
Configure bandwidth contract (256 Kbps - 2 Gbps)
Configure rules to derive user role or vlan
Set DNS query interval
Password policy for locally configured management users
Configure an AAA Profile
Configure RADIUS attribute
Configure a Server Group
Configure accounting
Configure authentication timers
User commands
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
exit
Advertisement
Table of Contents
