Show Interface Ets - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)

show interface ets

Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type fortyGigE/tenGigE X/x ets detail
Parameters
interface
detail
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
Information
Example
(Summary)
Example
(Detail)
Dell#show interface fortyGigE 0/36 ets detail
Interface fortyGigE 0/36
Max Supported PG is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp
BW-PEAK
Rate(Mpbs) Burst(KB)
---------------------------------------------------------------
Data Center Bridging (DCB)
Description
Introduced on the Z9500.
Enter the port-type which can be ten GigE or forty GigE and
port ETS information.
Enter key details for a full list of results.
Description
Introduced on the Z9500.
NOTE: Please note that the show interface ets detailsare updated
with Minimum and Maximum bandwidth details.
Priority#
TSA
BW-% BW-COMMITTED
% Rate(Mbps) Burst(KB)
615