Dot1X Host-Mode - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

If the host fails authentication for the designated number of times, the

authenticator places the port in authentication failed VLAN (dot1x auth-fail-

dot1x host-mode

Enable single-host or multi-host authentication.

dot1x host-mode {single-host | multi-host | multi-auth}

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.0.0.0

NOTE: You can create the Layer 3 portion of a guest VLAN and authentication

fail VLANs regardless if the VLAN is assigned to an interface or not. After an

interface is assigned a guest VLAN (which has an IP address), routing through

the guest VLAN is the same as any other traffic. However, the interface may

join/leave a VLAN dynamically.

dot1x auth-fail-vlan

— Configure an authentication failure VLAN.

dot1x reauthentication

dot1x reauth-max

Configure the maximum number of times to re-authenticate a port before it

becomes unauthorized

Enable single-host authentication.

Enable multi-host authentication.

Enable multi-supplicant authentication.

Introduced on the S6000.

Introduced on the Z9000.

Introduced on the S4820T.

Introduced on the S4810.

— Enable periodic re-authentication of the client.