Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check
operation is started.
S4810
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Defaults
3 ccms
Command
ETHERNET CFM
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
172
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Enter a start-delay in seconds. The range is from 3 to 100
seconds.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
802.1ag